Dana is a global leader in the supply of highly engineered driveline, sealing, and thermal-management technologies that improve the efficiency and performance of vehicles with both conventional and alternative-energy powertrains. Serving three primary markets - passenger vehicle, commercial truck, and off-highway equipment - Dana provides the world's original-equipment manufacturers and the aftermarket with local product and service support through a network of nearly 100 engineering, manufacturing, and distribution facilities.

Duties and Responsibilities:

• Operate Press/Cell

• Finish, Inspect, and Pack Parts

• Record all defects and scrap

• Record pieces produced

• Complete all required paperwork

• Practice safety at all times

• Perform special instructions/requests as determined by the Supervisor

Requirements:

• Must be able to stand for an 8-12 hour shift

• Must be able to lift up to 10-20 pounds occasionally

• Must be able to climb stairs occasionally

• Must be able to reach into press and pull parts from mold

• Must be able to stoop or bend to clean mold

• Must be willing to rotate jobs

• Must be available to work any shift as assigned

• Must be able to run all compounds

• Attendance is mandatory and must be on time for work

• Must be willing to work overtime when needed

• Must practice good housekeeping

• Must be flexible and willing to perform any task assigned by Supervisor

We are an Equal Opportunity Employer and do not discriminate against any employee or applicant for employment because of race, color, sex, age, national origin, religion, sexual orientation, gender identity, status as a veteran, and basis of disability or any other federal, state or local protected class.